Water Jet / Plasma Cutting Services

Davron utilizes both high-definition plasma cutting and abrasive waterjet cutting systems in our manufacturing facility. Both of these systems allow us to provide cost reductions, improved lead times, and higher quality products with precision cuts.

These cutting systems are used in our manufacturing process every day for making oven components. However, we also offer our cutting services to outside customers for various parts and components.

Plasma cutting

Our high-density plasma cutting system is an AKS Cutting Systems accu-kut Plasma Cutting System with a Hypertherm XPR300. This system allows us to cut mild steel from gauge to 3″ thick.

Features and benefits of our plasma cutting system

  • 5’ x 15’ cutting table
  • Dual linear guiding and worm gear drives with digital motors produce movement of the machined gantry. Resulting in precise cuts and round holes
  • High-speed dual drives allow for speeds in excess of 2,000 ipm while providing maximum torch cutting speeds

Water jet cutting

Our Flow Abrasive Water Jet Cutting System utilizes an integrated flying bridge with a dynamic head. The pump utilized on our system is a 60,000 psi HP Intensifier. This system cuts a wide variety of material such as stone, copper, UHMW, wood, tile, stainless steel, rubber, composites, aluminum, carbon steel, brass, foam, etc.

Features and benefits of the flow abrasive water jet cutting system

  • 6’ x 12’ cutting bed
  • Z axis material thickness up to 6”
  • Accuracy of +/- 0.004”
  • Repeatability of +/- 0.002”
  • Edge quality – no heat affected zones
  • No mechanical stresses
  • Easy to program
  • Thin stream (0.04” in diameter)
  • Extremely detailed geometry
  • Thin material cutting
  • Little material loss due to cutting
  • Stack cutting
  • Low cutting forces (under 1 lb. while cutting)
  • Reduce secondary operations
  • Little or no burr